Hello all,
I am having copy of the Robo-Guide WeldPro and have not any hardware requirements for it and don't know how to run it smoothly. I wan to run it over my laptop so that i may move it all around my work-station. Can anyone of you give me any suggestions? Do i need to have a full software or it has a 30 day trial?
Thank You
Didn't find what you were looking for?
New post
Hello Friend
Kindly follow the steps for any version of roboguide . You will find the system requirements
You can purchase one license and can use on multiple system . but it can be run on one system at a time.
Dear chang,
The question which you asked is very basic. I will give you a detailed answer by the way, as I think you might be new to the robotics.
Yes, You can install a 30 day version which is free of cost and you may install same software on different computers. However, when the trial version gets expired then do not erase the documents that you have. The license of robo-guide can be easily moved from one computer to another computer through mere a USB, therefore allowing a single license to be used in different computers. But only the software will be active on one computer at a time. I have done so many times.
I believe you can also set the keys up over the network for allowing the robo-guide software to be opened through any computer using a specific network. Now, if you have a single license then you can use it over a single computer.
Please sign in to leave a comment.
Comments
4 comments