1. DIY-Robotics (Help Center)
  2. Community
  3. Electrical Design

Is there any way for creating the Jog Frame without saving steps?

Avatar
Chang Thriving

Hello guys, 

I believe I have asked this question before. I have been working on FANUC robots for over 8 months now and had no learning about it before i started working.

I have been trying to create a new jog frame on my robot which i used for welding at my work station. I have been obeying the methods necessary for the robots but still couldn't make it. There was a warning in the methodology that if you would not save the newly created frame then you will not be able to get it in to its original conditions. So, I am not caring of the saving of files but the time when I complete the entire steps, I am trying to find a way to make new jog frames which i am not able to do.

Therefore, my question is that is saving necessary to be done at each step or is there any chance if i could skip saving any step? Have any of you ever created a Jog Frame without Saving?

Thanks in advance for sharing your feedback with me

Didn't find what you were looking for?

New post

Comments

1 comment

Sort by Date Votes
  • Avatar
    Muhammad Ishaq
    Comment actions Permalink

    Dear Chang,

    You should have mentioned the type of controller which you are using. 

    Generally speaking when a new Jog Frame is taught then it is achieved by the time when last point of the method to be recorded. However, if you are not able to toggle the Jog Frame through Pressing the COORD button then you are suggested to alter the variables of the system.

    0

Please sign in to leave a comment.