Mathieu Chénier
Comments
-
ok it works. everything solve thanks
-
there is a procedure of recovery for this alarm. Is it recommended?
-
Yes they are
-
where are the e-stop board? the e-stops line are connected to the board in the picture above. This adapter are connected to a big board. take note that i bypass the pin 4 to 6 and 38 to 40 for the ...
-
Ok Mathieu, so the pin 5 to 6 have been modify for pin 4 to 6 and pin 38-40 were good. we have new errors, Srvo-230 and srvo-231. Any tips?
-
For your comment, (The External Estop is the pin 6 and 40. You need to supply 24V (from the pin 2,3 or 4) to the pin 5) When you say to the pin 5, do you mean i shoud be plugged into pin 4 and 5 or...
-
-
You need to know that we eliminate the cooperative relays that were plugged into the connector in the picture. (connector name on the card is CRR63) I need information for the crmc19 (drawing you p...
-
i have a doubt because the pin 5 in your drawing is sd1com1 and i'm not plugged into sd1com2 at pin 39, i'm plugged into pin 38... maybe i'm plugged at the wrong place??
-
My e-stop line are connected to pin 5-6 and 38-40. Is it ok?