Mathieu Chénier
Comments
-
Hi Mathieu, tanks for the tip. We do not provide 24vdc and 0v to these pin. They only are jumped togheter. when i measured it, from 0v and 24vdc jumper, i have 24vdc
-
Ok there was a pin in te connector that pops out. I pushed it in and i have no more the SRVO-378. But the code SRVO-007 still remains either if i jump the pin 5 and 6 for chanel 1 and i jump the ...
-
Good morning, first of all, i've checked the voltage and everything should be correctly connected. The reason i had two voltages is because i also measured the voltage that pass thrue the contacts ...
-
-
i will continue on monday, would you be available
-
if it come from the robot, can you tell me what voltage i should have on EES11 and EES21? i don't have a plan for the robot, for witch volatge i should have on each pin... Can you provide?
-
at page 4 on the safety relay, terminal 13. i know that on terminal 13 there are contacts and it goes to terminal 14. Is the power come from EES1 from the robot or from the controller panel?
-
Also, my alarm is svo-378 (SFDI11)
-
I found an DIY electric diagram in my documents. The project number is 10818. the 24v is coming from the robot controller panel. I'm not sure where i should put my tester lead
-
Hi Mathieu, I am Mathieu, Emile's partner and i am the one who did the voltage test. in my e-stop circuits, i have 2 doors relays (with 2 contacts in series), 1 safety relay and the e-stop on my sc...