Dimitry Vasilkov

Answered

7th Axis Rail Mastering

1. Community
2. Mechanical Design

Hello ,  We have M16iB with 7th Axis Rail. As a part of periodic maintenance , we encounter a position offset of 2mm in rail axis. Anyone has idea how to perform mastering on this 7th axis rail ?    

• Created February 01, 2020 05:51
• 3 followers
• 3 comments
• 0 votes

Answered

Alarm 1547

1. Community
2. Troubleshooting — FANUC

Hello All ,  I have this alarm it says current feed back error. So what can be the issue. It is popped up on my screen.  Can any one help me with this ?  

• Created January 31, 2020 11:51
• 2 followers
• 1 comment
• 0 votes

Answered

INIT START

1. Community
2. Troubleshooting — FANUC

How to perform INIT start ? Error message says , Perform INIT start ! What will happen , If INIT start will be done ? Robot will be formatted ? Is there anything i need to make precautions ? Please...

• Created January 28, 2020 06:10
• 2 followers
• 1 comment
• 0 votes

Cycle Power

1. Community
2. Troubleshooting — FANUC

Hello ,  I was teaching a program and suddenly i encountered an issue. I called up my friend , He suggested me to perform certain changes and do the cycle power. i have changed what he suggested bu...

• Created January 22, 2020 11:28
• 2 followers
• 2 comments
• 0 votes

Answered

SAFETY CIRCUIT

1. Community
2. Electrical Design

Hello Everyone ,  I am looking for safety circuit wiring. Which safety board is good and how to do the fence wiring with controller ? Thanks .

• Created January 16, 2020 14:50
• 2 followers
• 3 comments
• 0 votes

SVGN-096

1. Community
2. Troubleshooting — FANUC

Hello Folks , What can be the reason for this alarm ?  Any guidance will be appreciated ..!!!  Thanks 

• Created January 15, 2020 13:59
• 1 follower
• 1 comment
• 0 votes

Answered

SRVO-310

1. Community
2. Troubleshooting — FANUC

Hello ,  I am getting the alarm SRVO-310 after mastering the robot. What is wrong ?  Do i need to do it again ?  As it consume too much time. Looking for someone who has any experience with this al...

• Created January 12, 2020 13:40
• 3 followers
• 2 comments
• 0 votes

Answered

DCS UNAVAILABLE ALARM

1. Community
2. Troubleshooting — FANUC

Hello Friends ,  I am getting this alarm !!  SYST-218 DCS UNAVAILABLE  Do anyone have experience with this alarm ? And how to remove it ? What are the steps ..!!  Thanks a lot.. !

• Created January 11, 2020 14:01
• 3 followers
• 1 comment
• 0 votes

Answered

Alarm

1. Community
2. Troubleshooting — FANUC

Hello Everyone ,  Can anyone help me with these alarm ? SRVO - 037 & SRVO - 004 Thanks 

• Created January 07, 2020 13:00
• 2 followers
• 2 comments
• 0 votes

Answered

GE FANUC 90 30 PLC

1. Community
2. Troubleshooting — FANUC

Hello ,  Which software i can use to program GE 90 30 PLC ? Thanks 

• Created December 07, 2019 12:18
• 3 followers
• 2 comments
• 1 vote