Chang Thriving
Comments
-
Dear Muhammad, Thank You. Dear Coleman, It is an LR Mate 200iD model with R30iB controller.
-
Hi, For the RJ system do following. Open up the menu for I/O and then press function and save. The I/O data will be backed up. Similarly, for the menu, setup, frames, user-frames, and tools, functi...
-
Hi Laurance, The purge system is measuring three of the main parameters i.e. higher pressure, lower pressure, and flow of air. During the start of the system which is needed to be at lower pressure...
-
Dear Juan, If the robot is moving in an arc position then mastering is OFF and you are required to correct the problem at first chance. You are required to set the tool frame to ZERO point and then...
-
Dear Juan, Do you have any fault associated with this problem?
-
Dear Howard, AR[1] is known as the argument which is used when calling the sub program. It is the best way for passing data to other programs for using another line for putting it in to register. W...
-
Dear Coleman, I would suggest you to store them in the position register as follows. PR[...]=UFRAME[...] After that you can restore it and use command as follows FRAME[ ]=..." in the "Offset/Frames...
-
HI Ishaq, Thank you so much for your response. Now I am able to understand that I have to change the right mode of welder. However, I have another question that which of the overlays I will be usi...
-
Hi coleman, Both AP1 and AS1 ports are free to be used as these are cables which are running through base of robot to J4. You can also use these for the purpose of digital Inputs and outputs etc.
-
Dear Mohammad, I am succeeded finally. I have found the PCMCIA card which I have been looking for and it had .exe extension for running it to get files for transferring the files from the TP to the...