Chang Thriving

1. Community
2. Troubleshooting — FANUC
3. Robot is loosing memory when it boot it up

I think this issue is related to COLD START reboot. Therefore you are required to check first variable in "System/Config" menu: "Use HOT START" should be TRUE.

• View comment
• Created December 12, 2019 17:23
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Interaction with input of TP-Karel Program

I think you are required for creation of dialog display and then you must be asking the operator to enter data in form of variables. In one of the KAREL manual's which I used few months back for RO...

• View comment
• Created December 12, 2019 16:57
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Need an IR Vision Setup for my FANUC.

Hi Juan!The IR vision manual of Operator is having the necessary information for the fundamental steps to create a vision program successfully. I have personal usage experience of the manual for se...

• View comment
• Created December 10, 2019 11:50
• 0 votes

1. Community
2. Mechanical Design
3. Robot base designing

Hi Erturo!You can calculate the maximum forces and torques that the robot applies to the base as follows. Calculate the mass of robot if not known.  Make a free body diagram of the robot, having k...

• View comment
• Created December 04, 2019 08:46
• 0 votes

1. Community
2. Mechanical Design
3. Payload Calculation

Dear Dimitry, You don't need to calculate the load at EOAT because in the manual of the robot system everything is given in calculated form. The name of manual is FANUC Robot LR Mate 200iC and FANU...

• View comment
• Created December 04, 2019 08:14
• 0 votes

1. Community
2. Mechanical Design
3. CAD file of Fanuc M-10iD/12 robot

Hello dear Gabos Tibor!Here are some links where you can find the CAD (Solidworks) files of the FANUC M-10iD/12 Robot for sure. I have checked these links and are working fine. Solidworks CAD files...

• View comment
• Created December 04, 2019 07:45
• 0 votes