Howard Coleman

1. Community
2. Troubleshooting — FANUC
3. Question regarding jog frames of FANUC.

Hey Frankie! I am glad you asked this question as I am delighted to say that I have been using jog frame with my FANUC robot and I gave an angle of 20 degrees as per ground reference.  Moreover, I ...

• View comment
• Created December 09, 2019 10:28
• 2 votes

1. Community
2. Mechanical Design
3. Purge System Testing

Hi Ernesto, There are various methods through which you can check Air Leakage. Some of the widely adopted methods are as follows. 1.Bubble Test/Submersion Test. 2. Ultrasonic Measurement 3. Pressur...

• View comment
• Created January 29, 2020 12:37
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Stopping FANUC motion in mid of a cycle

Hi Frankie, For an interruption in motion in the middle of a movement, you should use the skip instruction. Good luck

• View comment
• Created January 28, 2020 08:15
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Imbalance movement of RJ2

Yes, I think that mastering of the robot is not okay. Sarwat has got it right because when you will jog all of the axis to zero then the arm would stand firm and straight. So make sure your masteri...

• View comment
• Created December 18, 2019 12:09
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Need an IR Vision Setup for my FANUC.

Hey howard!Do you mean visual tracking or static vision? You want to to install any software tool in the robot or program it? You may get suggestions for the problem but i will enforce you to have ...

• View comment
• Created December 10, 2019 12:34
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Copy of Software needed for FANUC

Hey juan!I think you must change your controller because this is too old. I will suggest you to call FANUC helpline for help if you like. Thank You

• View comment
• Created December 10, 2019 12:30
• 1 vote

1. Community
2. Electrical Design
3. Test Motor for a short

The basic test for checking the motor short is as follows. Testing the direct shorts of the motor winding for induction which is non-brush type motors. Keeping the multi-meter to a value of 30,000 ...

• View comment
• Created December 09, 2019 10:36
• 1 vote

1. Community
2. Mechanical Design
3. What is the best way for developing robots in that of V-REP or even RoboDK?

Hi Following link may be of great help to you. https://pdfs.semanticscholar.org/0d8a/22f3981375bccd8c4664ac3d58f2bf6dc1d1.pdf

• View comment
• Created December 05, 2019 10:22
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Backup of the RJ2 Controller

Hey Samuel, This is only possible if you are having a CONTROLLER BACKUP option installed, else you can backup through TP programs settings and I/O. Good luck

• View comment
• Created February 07, 2020 12:06
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Transferring the rotational data to the machine tool through IR Vision?

Dear Isa, I am happy to tell you that, right now i am working on the implementation of this concept. You are having FANUC control? If yes, then the easiest way to go is through IO link. However, it...

• View comment
• Created February 06, 2020 10:03
• 0 votes