Gabriel Hallée

1. Community
2. Troubleshooting — FANUC
3. INTP-311 Uninitialized data is used in a KAREL program (R-30iB)

Hi Cody,INTP-311 is a KAREL program error. It means the program tried to use a piece of data that was never given a value: a variable that gets read before anything sets it, or a position it uses t...

• View comment
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Payload error after new calibration

Hi Camila,   The first thing I would check is the payload setting. If the robot moves on its own when activating free movement, it usually means the payload is not configured correctly. The alarm y...

• View comment
• Edited April 16, 2026 15:32
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. problème suivit axe repère utilisateur

Bonjour Jean,   La différence entre les variables MASTER_COUNT et REF_COUNT n’est probablement pas la cause de ton problème. L’écart que tu observes est minime et pour le contexte, voici leurs rôle...

• View comment
• -1 votes

1. Community
2. Troubleshooting — FANUC
3. problème suivit axe repère utilisateur

Bonjour Jean,   Merci pour le support visuel. J’en comprends donc qu’il ne devrait pas y avoir d’enjeu concernant l’équerrage de votre surface de travail.   Je ne crois pas qu’il soit nécessaire de...

• View comment
• Edited January 06, 2026 15:53
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. problème suivit axe repère utilisateur

Bonjour Jean,   La première chose à valider serait la précision du User Tool (TCP) utilisé pour enseigner le User Frame.Nous vous recommandons d’utiliser une pointe de précision montée sur le robot...

• View comment
• 1 vote

1. Community
2. Programming — ABB
3. Confusion about ABB SafeMove versions (Standard, Standard+, Premium, Premium+, Pro)

ABB’s SafeMove options mainly differ in how much motion-supervision capability they give you. All versions use the same safety engine. The option level just unlocks additional features.   Here’s a ...

• View comment
• Edited November 19, 2025 03:02
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Teach Pendant Black Screen following a cable failure

Sounds good, will be waiting on your feedback.

• View comment
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Teach Pendant Black Screen following a cable failure

Hi Isaak,   Assuming that your TP and cable both work on another robot, we can likely rule those out as the source of the problem. This points toward an issue inside the controller itself. The inci...

• View comment
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Teach Pendant Black Screen following a cable failure

Hi Isaak,   It sounds like your software may have become corrupted. I’d suggest forcing a Controlled Start by holding F1 and F5 during startup. This should open the Controlled Start menu, where you...

• View comment
• Edited August 15, 2025 01:33
• 0 votes

1. Community
2. Educative Cell
3. Fuse issue

Hi Sajal,I suggest that you take a look at the Electrical section of the user manual.You will find them in these locations (Red circles):   Happy thinkering!   Gabriel

• View comment
• Edited July 20, 2025 23:57
• 0 votes