Gerard Potter

Gerard Potter created a post, March 15, 2020 13:24
Answered

Matching points and calibrating with Roboguide and Robot
1. Community
2. Troubleshooting — FANUC
Hello Everyone , I have issue with the calibration. I have made a part reflecting the original part in cad. Imported that into software. Allotted user frame and tool frame. When i perform the cali...
- Edited March 19, 2020 11:24
- 2 followers
- 1 comment
- 0 votes
Gerard Potter commented, March 09, 2020 10:34
Before that try full mastering. Make sure you have master calibration number sheet with you and image backup. Also check encoder batteries as well. You may receive BZ alarm for that.
- View comment
- 0 votes
Gerard Potter commented, March 09, 2020 10:30
I see , If you have encoder issue. You are most likely to lose the position very often even after mastering and calibration. You will need to change the encoder. I think FANUC do not provide only ...
- View comment
- 0 votes
Gerard Potter commented, March 09, 2020 10:25
Hi Toby , Hope you are doing good. Can you confirm how old are they and how much time do you run in a single day ?
- View comment
- Edited March 09, 2020 10:25
- 0 votes