1. DIY-Robotics (Help Center)
  2. Community
  3. Mechanical Design

Answered My FANUC is having startup issue

Avatar
Chang Thriving

Hi everyone...

I have my FANUC S10 robot arm, and it has a problem with startup.

When I am about to turn ON its control panel it shows me an error "Error in CM0 Module: Error 109 , parity error, Error 45, controller non boot-label".

After this everything is freeze and I am not able to move anything.

I have checked the LED status inside the control panel, everything seems fine.

The Motor are not energized and also the LED on the front panel are not turned on.

Please anyone can tell me what can the problem be?

(Shared memory?, fuses?, something missing?)

I am waiting for a real answer.

Didn't find what you were looking for?

New post

Comments

1 comment

Sort by Date Votes
  • Avatar
    Sarwat Anjum
    Comment actions Permalink

    Hi Chang!

    I am not sure but the maximum i could get from your described issue: Most likely you'll need to replace your main board. if you do this take a backup because the contents of MEM (parameters, specific data, etc) will be lost.

    Hope this was helpful!

    0

Please sign in to leave a comment.