I am having an issue.
I have a question that whether there is any way for rotation of weave either around Y or X axis? I am able to utilize the weave easily among two points, but I am not able to have a welding seam among a flat plate and a 90 degree plate and I would like to weave on a 45 degree angle.
I wonder if this is possible?
Didn't find what you were looking for?
New post
I would suggest that after you are done with checking the setup of the tool frame correctly then you have to check for the angle approach of torch and that is far enough. Weaving motion is always relative to that of the tool frame. In special conditions, where approach angle is not changing then use of azimuth is a must which is allowing to enter the angle among y component of weave vector with that of the weave frame of y-axis. This is also allowing you changing angle of weave because if are not rotating the tool then this will be changing the alignment of y along with x axis.
Hi Juan!
The weave plate is following frame tool and as long as the torch is at 45 degrees in horizontal to the plate, there is no problem that you may have in right weave of corner. By the way, have you ever tried it? Make sure your tool frame is setup correctly.
The above options are good, however you can also try another option that is trying navigation of the weave setup screen as follows.
1. Menu
2. Setup
3. Weave-from there scroll down to the azimuth and change to 90 degree or 45 dergree whatever you desire. 90 degree acts more like a back step than weaving side to side.
goodluck
Please sign in to leave a comment.
Comments
3 comments