1. DIY-Robotics (Help Center)
  2. Community
  3. Electrical Design

System-035 alarm: Replacing Lithium Battery

Avatar
Ezequielo Murillo

Hi Guys!

My Teach Pendant is displaying System-035 Alarm. I have searched, it indicates low-voltage battery. Can somebody help me with replacing the battery and am i getting this alarm right?

Any help will be appreciated.

Didn't find what you were looking for?

New post

Comments

2 comments

Sort by Date Votes
  • Avatar
    Sarwat Anjum
    Comment actions Permalink

    Replacing the lithium battery

    1. Prepare a new lithium battery
    2. Turn the robot controller on for about 30 seconds.
    3. Turn the robot controller off.
    4. Pull out the battery unit located in the lower right part of the backplane unit. (Hold the latch of the battery unit, unlatch the battery unit from the case, and pull out the unit.)
    5. Install a new battery unit. (Insert the battery unit until the latch of the unit snaps into the case.)
      Check that the battery unit is latched securely.

     

    Complete the steps (3) to (5) within 30 minutes. If the battery is left disconnected for a long time, the contents of memory will be lost. To prevent possible data loss, it is recommended that the robot data such as programs and system variables be backed up before battery replacement.

    Have a Good Day!

    0
  • Avatar
    Sarwat Anjum
    Comment actions Permalink

    Hi There's something you need to keep in mind while replacing the battery. Using other than the recommended battery may result in the battery explosion. Replace the battery only with the specified battery (A05B-2550-K030).

    And Dispose of the replaced battery as an industrial waste, according to the laws and other rules in the country where the controller is installed and those established by the municipality and other organizations that have jurisdiction over the area where the controller is installed.

    Thanks!

    0

Please sign in to leave a comment.