1. DIY-Robotics (Help Center)
  2. Community
  3. Mechanical Design

Answered Fusion 360 to Fanuc

Avatar
Braylen Mcconnell

Hello , 

I have prepared .nc file in Fusion 360. Is it possible send the milling file directly to the Fanuc Controller ? How ? 

Thank you.

 

Didn't find what you were looking for?

New post

Comments

2 comments

Sort by Date Votes
  • Avatar
    Sarwat Anjum
    Comment actions Permalink

    Hi Braylen,

    You can convert in to G-code and send it to your Fanuc controller. If the controller has a serial port, then all you need to do is configure the serial port and then do a VISA Write to send the codes and a VISA Read to get them back. In both cases, you'll need to know the command to send to the controller to prepare it for a new program or which program to read. The controller should have some documentation that explains this.

    I am attaching link that might help you.

    https://www.youtube.com/watch?v=Qt-1ap3du6Q 

     

    0
  • Avatar
    Braylen Mcconnell
    Comment actions Permalink

    Appreciate your help Sarwat. !! 

    Good day. 

    0

Please sign in to leave a comment.