1. DIY-Robotics (Help Center)
  2. Community
  3. Troubleshooting — FANUC

Answered Fanuc Arcmate 120 iC burns tip of the weld

Avatar
Masako Cynesige

Hi Y'all!

I am using a FANUC Arcmate 120iC with a servo torch and a Lincoln 455 Powerwave for .035" aluminum wire and we cannot get it to stop burning tips very often. The welds look great but it burns the tip at the start of the weld quite often. What causes this?

Didn't find what you were looking for?

New post

Comments

2 comments

Sort by Date Votes
  • Avatar
    Toby cooke
    Comment actions Permalink

    Masako Cynesige

    Major issue i can feel is the welding parameter. You need to have the right parameter for your welding. As well as check fire feeder setting. If you are using voltage feedback option , Check the wiring. 

    Let us know if you have sorted out the issue. 

     

    1
  • Avatar
    Masako Cynesige
    Comment actions Permalink

    Issue was resolved. it was too many volts for the amount of wire I were using. Thanks

    0

Please sign in to leave a comment.