1. DIY-Robotics (Help Center)
  2. Community
  3. Troubleshooting — FANUC

SYST-155 ABC OVERRUN

Avatar
Losev Radinovich

Hey guys, 

I searched manuals for this alarm, but could not find the actual remedy !! Can you help me to solve the issue ? 

 

Didn't find what you were looking for?

New post

Comments

2 comments

Sort by Date Votes
  • Avatar
    Masako Cynesige
    Comment actions Permalink

    Dear Losev,

    If there's no information available in manuals . You would have to contact FANUC Robotics on this one. Basically it is an internal error you do not see normally. It indicates that controller's Central processing unit was too busy to service the Control task and it timed out. There cab be both hardware or software reasons which can cause this.

     

    0
  • Avatar
    Muhammad Ishaq
    Comment actions Permalink

    Hi Losev,

    Please POWER ON and OFF your robot which would most probably resolve this error.

    I had such error a week ago and it went-off in such a way.

    Good Luck

    0

Please sign in to leave a comment.