1. DIY-Robotics (Help Center)
  2. Community
  3. Troubleshooting — FANUC

Answered Vision simulation error

Avatar
Ezequielo Murillo

Hi Everyone,

I am facing issues setting up Vision simulation. I have connected the camera to one of the ports of the robot controller.  I have not experience of vision simulation, I am getting this error "Failed to generate camera setup CVIS-722 The camera specified cannot be found" while executing "generate camera data command". I have seached but could not find anything like this. Can anyone Help me here?

Thanks in advance!

Didn't find what you were looking for?

New post

Comments

1 comment

Sort by Date Votes
  • Avatar
    Sarwat Anjum
    Comment actions Permalink

    Hello Ezequielo,

    You should try restarting the Roboguide and re-create the camera and disconnect the camera from robot and try another port it would clear if it is a port issue. 

     

    0

Please sign in to leave a comment.