1. DIY-Robotics (Help Center)
  2. Community
  3. Troubleshooting — FANUC

SYST-070

Avatar
Ezequielo Murillo

Hi Experts,

We are working on two MIG fanuc welding robots, putting on a couple welds a on piece of shaft. The main program is in style 10 but now we want to change it to a style 11 which will work like: one robot picks the part and the second welds it. We have successfully installed the program. And working fine in manual run but not in auto.

When we start the auto cycle we are getting the alarm: 

  • SYST-070: PUT A VALID PROG NAME IN THE START TABLE

I am new this these robots. Can anyone help me out here?

Didn't find what you were looking for?

New post

Comments

1 comment

Sort by Date Votes
  • Avatar
    Bailey Chapman
    Comment actions Permalink

    Dear Ezequielo  

    It indicates that you're missing the file go inside the program select MENU and check it, befor performing any further troubleshoots
    Most probably i would be program MAIN.

    0

Please sign in to leave a comment.