1. DIY-Robotics (Help Center)
  2. Community
  3. Troubleshooting — FANUC

Answered The process of welding

Avatar
Jordi Golden

Hello all,

I am going to ask a question. It may sound silly but i need an answer.

How will i be able to change the process of welding? Is there any way or not? I am working on 100iC controller.

Thank You

Didn't find what you were looking for?

New post

Comments

4 comments

Sort by Date Votes
  • Avatar
    Vicky Kanne
    Comment actions Permalink

    Follow this video , You can change welding parameters. I hope it will be helpful.

    https://youtu.be/NpJz1JObpN4?t=347

    0
  • Avatar
    Juan Turner
    Comment actions Permalink

    Hey Jordi,

    Are you able to access the variable that you are desiring in the welding register?

    Here is the way to access.

    <Data>

    <Weld Schedule>

    <Detail>

    Regards

    0
  • Avatar
    Muhammad Ishaq
    Comment actions Permalink

    Hi,

    You might have a requirement of the multi-process to be enabled.

    It's been a very long time since I did this. However, I think that it can be done through CRTL start set $AWSCFG.$MULTI_PROCESS=TRUE.

    Good luck

    0
  • Avatar
    Jordi Golden
    Comment actions Permalink

    Dear Ishaq,

    Wow it is working fine.

    Thank you so much

    0

Please sign in to leave a comment.