1. DIY-Robotics (Help Center)
  2. Community
  3. Electrical Design

New to the Fourm. Looking for some guidance with Euromap 73.

Avatar
Raymond Coe

Hello all,

I'm looking for some insight on a project that I've been assigned. I'm currently replacing our hydraulic IMM machines with electric ones. I have a variety of pick & place and 6 axis robots depending on the process. Through the years there have been many flavors of Euromap used.

My project involves a Roboshot IMM with coupled Euromap 73 standard. The associated Pick and Place (Proprietary build) is Euromap 12. You may see where I’m going with this…. I need make the 12 work with the 73.

When I look at the 73 interface, I’m not finding some of the pin out assignments that I’m looking for. For instance, Mold Open, Mold closed, and Ejectors back, etc. I do see all the Estop and safety pin outs.

My question is 12 to 73 possible and if so, will I be self assigning pin outs using the "Spare- Not Fixed" portion of the plug?

Thanks in Advance,

Ray

Didn't find what you were looking for?

New post

Comments

2 comments

Sort by Date Votes
  • Avatar
    Mathieu Berube
    Comment actions Permalink

    Hi Raymond,

    The Euromap 73 is usually used for the External Safety Device like replacing the back door of the IMM with your fences. If you are looking to replace the Euromap 12 function (Mold Open, Mold closed, and Ejectors back) the one you should look for may be the Euromap 67. 

     

     

    DIY-Robotics products
    https://diy-robotics.com/products/

    1
  • Avatar
    Raymond Coe
    Comment actions Permalink

    Hello Mathieu,

    Thank you for your response. 

    So, I believe that I am on the same page as you after looking at the machine. To my surprise I found two plugs sitting on the machine. One for the external safety devices (73) and the other for robot connector (67). Time for a redesign! 

    Thanks again,

    Ray

     

     

    0

Please sign in to leave a comment.