DIY Support - Support
Comments
-
Mattie Hook, I see an AP_LD (approach linear) at the end of your pick point (2). If the "CNT" termination is closer than your approach distance, it will not be executed. So you can try to reduc...
-
Hello Mattie Hook, Can you share your program or a video of your robot? So we can understand better what is wrong. DIY-Robotics productshttps://diy-robotics.com/products/
-
Monty,You can see your Payload configuration by pressing MENU, -- NEXT --, SYSTEM, motionBe sure that the right value of your tooling is there. At the bottom of this page, you will see which pa...
-
Hello Steven, What file are you trying to load? What's your file extension? DIY-Robotics productshttps://diy-robotics.com/products/
-
A good way performs this is to link your DO directly with the fault (or running) signal of your robot. You can make a BG logic program with something like: - DO[XX] = !UO[6 : Fault] or - DO[XX] =UO...
-
Hi Steven, Use the key SHIFT and DISP simultaneously on your teach pendant, then you can select Single. DIY-Robotics productshttps://diy-robotics.com/products/
-
Hello Ching, can you send your actual config and tell us which assignment you are trying to delete?
-
Hello Monty Goddard,First, be sure that the robot didn't make any collision. When you increase the robot's speed, the path can change on point with CNT termination.Second, be sure that you have...