Mathieu Berube
Comments
-
Ok you need to recalibrate the robot. Simply follow this procedure: https://diy-robotics.zendesk.com/hc/en-us/articles/360035963732-Single-axis-quick-mastering-procedure
-
You will have to reamster the robot. You should have a BZALARM. To do a mastering procedure, folow this tutorial: https://diy-robotics.zendesk.com/hc/en-us/articles/360035963732-Single-axis-quick-m...
-
If you press enter on your program, can you edit it?
-
Can you show us a picture of the full teach so we can see if there's an alarm? Try to open your program in the old interface: 1. Press on the menu (top left) 2. Press to open the full menu versio...
-
The current issue seems to be that the tablet is unable to connect to the robot. If you're able to jog and operate the robot using the classic teach pendant but not the tablet, there may be a probl...
-
Hi, If you have a recent backup ''all of above'', you can restore everything from there with a Controller backup / restore Put your backup on a usb stick plugged in UD1 and use the restore option
-
This USB cable on the back of the teach
-
Hi,Does this error occur during a specific movement of the robot? If yes, try increasing the acceleration at that point. Set it to ACC50 and check if this resolves the problem. There's also some ot...
-
In this case, there seems to be an issue with the tablet's connection. 1. Check if the cable is properly twisted in place. 2. Ensure the USB is securely plugged in. 3. Close the Fanuc application o...
-
Does it boot? Do you see a gray screen?