Christopher Bradley

1. Community
2. Troubleshooting — FANUC
3. Fanuc M20iA, Fault reset function not working

Rejean, is your cell is OK ? I had this type of problem. See IO Status SI[1]. The "Reset Fault" blue push button always ON and lock other reset function.

• View comment
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Interaction with input of TP-Karel Program

Muhammad Ishaq, PAC Code Fanuc free, i'm not sure about that. All PAC Code is unic. When buy a PAC Code, this information is required: 1. F-Number2. Controller ID3. Software Serial Number4. Control...

• View comment
• 0 votes

1. Community
2. Electrical Design
3. Do anyone has an idea of the FANUC support or encoder replacment?

Hello Laurence, it's possible to buy Encoder Only or Complet Kit Motor/Encoder. In October 2018, I buyed a Encoder for repair a Pulses Encoder Error on Fanuc M10i-A J3 Motor. No part mismatch and n...

• View comment
• 0 votes