Toby cooke

1. Community
2. Troubleshooting — FANUC
3. Display Cycle Time

Create a BG Program  TIMER[1]=RESETTIMER[1]=START ...(Process you want to time) R[100:Process Time]=TIMER[1]TIMER[1]=STOP R[X]=TIMERX It will show live timer 

• View comment
• Created January 29, 2020 12:37
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Operating Hours

Oh , Thank you for information..   

• View comment
• Created February 01, 2020 12:53
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Controlled start to normal operation

Ernesto Perito May be you are trying to install any update or any option which would require to perform that action in controlled start only. I believe that option or setting may have changed the s...

• View comment
• Created January 29, 2020 14:49
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Fanuc Arcmate 120 iC burns tip of the weld

Masako Cynesige Major issue i can feel is the welding parameter. You need to have the right parameter for your welding. As well as check fire feeder setting. If you are using voltage feedback optio...

• View comment
• Created January 25, 2020 20:12
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Singularity Avoidance

Ezequielo Murillo You can disable singularity option with this system variable.  $PARAM_GROUP[1].$snglr ty_stp - FALSE So Robot will not stop near the singularity point .    

• View comment
• Created January 24, 2020 20:18
• 1 vote

1. Community
2. Mechanical Design
3. Over Heating

Hello ,  You may need to clean the controller box at regular interval of time. It should be part of preventive maintenance . Sometime dusting in the fan grill can block the airways. Thus resulting ...

• View comment
• Created January 19, 2020 09:54
• 1 vote

1. Community
2. Mechanical Design
3. Purge System Testing

  You will need following equipment to perform the remedy procedure.   1. Air compressor / any air supplying source which is capable for supplying air approx  1000-1200 lpm.   2. Pressure gauge   ...

• View comment
• Edited January 17, 2020 18:34
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. IR-VISION SETUP

  Hello Sarwat, I read in manual , It has to be same IP address. However , I will try your method as well.  I m not able to open the IR Web server with Internet Explorer on PC. I dont know how to c...

• View comment
• Edited January 16, 2020 13:05
• 1 vote

1. Community
2. Mechanical Design
3. Robot's Irregular Vibrations while Jogging

  Hello Iqra ,  You should try the periodic maintenance and preventive maintenance mentioned in this post. I believe it will sort out your problem.  https://forum.diy-robotics.com/hc/en-us/communit...

• View comment
• Edited January 08, 2020 15:48
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. SRVO-135 FSAL ALARM

Hello Ernesto ,  Greetings for the day.  There is issue with the Fan. Check if the Fan is running. If not you need to change it.  Thanks 

• View comment
• Created December 17, 2019 11:49
• 1 vote