Losev Radinovich

1. Community
2. Troubleshooting — FANUC
3. INIT START

Dimitry Vasilkov Yes , Indeed it will remove everything on your controller. Factory mastering data will get also erased.  But before you do you will need back up of your necessary program files and...

• View comment
• Created January 29, 2020 10:45
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Controller Unidentified problem

Change TP cable 

• View comment
• Created January 22, 2020 04:28
• 2 votes

1. Community
2. Troubleshooting — FANUC
3. The robot position is out of stop tolerance

Hello,  I am not sure , But this can be the reason as your robot gets older and require calibration. Consider when your robot is moving and you suddenly hit a E-stop button or you just opened the d...

• View comment
• Created December 15, 2019 13:48
• 2 votes

1. Community
2. Electrical Design
3. Showing Robot alarms on HMI

Bailey Chapman  I am sorry , I do not know if there is any way around it. 

• View comment
• Created February 06, 2020 11:48
• 1 vote

1. Community
2. Electrical Design
3. Fan Not Working

Masako Cynesige Thank you so much for information. I just checked i received this SRVO-200 Alarm , When i started the controller. Luckily problem is solved now.   

• View comment
• Created February 03, 2020 15:34
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Device Net errors

DNET - 119 is because of baud rate difference. Try setting the baud rate below 500ms on both devices. 

• View comment
• Created January 31, 2020 15:16
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Alarms: Deadman switch abnormal & chain failure

Ezequielo Murillo As you stated , You have started troubleshooting with  TP Cable , E-stop , E-stop unit, E-stop fuses. So , I believe there is a hardware issue on the teach pendant . If you have a...

• View comment
• Created January 27, 2020 15:24
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Robot's axis problem

Bailey Chapman I sense two possibilities.  1. TP cable damage  2. Robot was mounted upside down configuration. Check all joint , if they are not mastered 180 offset.    Good day. 

• View comment
• Created January 26, 2020 12:05
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Weld robot backwards execution error

Bailey Chapman Change speed to CNT 100 --> FINE . Or try reducing the speed. I believe due to rough path and higher speed it may not able to Cop-up with the registered path.   

• View comment
• Created January 24, 2020 11:57
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Beep Sound

  You can go to system variable and unable it followed by restart.    $UI_CONFIG.$TOUCH_BEEP    1>        2>     3>     4>     5>     6>    

• View comment
• Edited January 22, 2020 10:25
• 1 vote