Laurence Price
Posts
-
Teh IRVISION for Welding
Hello, Does any of you ever succeeded in use of IRVISION for welding purpose of steel like CONEX boxes or beams used for structures or any other sort of sensor technology? I am using my robot M710/...
-
Answered
Hanging S420
Dear all, I am working on an old version of FANUC robot S420 having an RJ Controller which can move in the mode of manual joint but the problem is that it is hanging when any program is selected an...
-
Answered
TCP on Fanuc Robot
Hi everyone, I am using FANUC robot and trying to get an accurate TCP through 3 points method and 6 points method as well. I have even tried modifying the direct entry measurements. I have a weldin...
-
Abnormal indexer sweep: what to do?
Dear all, I am stuck here as don't know what to do and where to proceed? I am using FANUC RJ2 controllers. Does anyone of you have an idea about the indexes of robot from the sides A to B once in ...
-
The output wiring of the SFDO
Hello folks, I am in need to do the safety wiring of the output signal having a pulse check enabled with a safety relay. I am not able to figure out that how will i wire the output for activating ...
-
Answered
Checksum of the Teach Pendent
Hello guys, I am having a trouble with my FANUC's control board of teach pendent. I have already replaced the control board of the teach pendent to verify the problem. When robot is connected to th...
-
Answered
J2 Mastering out
Hi folks, I am having an ARCMATE 120iB/10L having a controller of RJ3iB. Recently I have hired operator and he is seeing few of the welds out of the position but, not all of the welds are out of po...
-
Question related to FANUC robot for paint
Hello folks, I am having a FANUC robot for the purpose of paint. For the flow switch what is needed to be done? Either closing the PSI or PSIG swithc? Need urgent help. Thanks
-
Answered
FANUCs Safety for avoiding collision?
Hello guys, I have to use 2 FANUC robots for an application picking up from common bench and are rotated in X. This will be resulting both robots for picking among 9 positions over then bench, howe...
-
FANUC machine Vision
Hello again, I am working on a automation project of robotics through a system of machine vision. I am not having any machine vision camera system with me and I know that IRVision cameras are way t...