Howard Coleman

1. Community
2. Electrical Design
3. Robot with missing name?

hi, I have to make a wild guess as you don't have enough enough given, so if the robot is about decade old than it's controller should be RJ3iB.

• View comment
• Created January 10, 2020 12:23
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Auto mode speed mixed variation

I think that you have a problem that program may be overwritten by command [override=5] in TPE or [GENOVERIDE=5]. Check the program and if possible then paste program here.

• View comment
• Created January 10, 2020 12:07
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Starting issue of init

Hy laurance, actually i was afraid of the init start error so yes i made backup and none of the mastering or other is lost. I have loaded the file and is working well, nothing seems to have lost

• View comment
• Created January 10, 2020 11:55
• 0 votes

1. Community
2. Electrical Design
3. What is meant by MOTN049 calibrated in FANUCs?

hi turner, i just got it. thanks

• View comment
• Created January 09, 2020 18:12
• 0 votes

1. Community
2. Electrical Design
3. What is meant by MOTN049 calibrated in FANUCs?

Dear Frankie, yes, but I cannot find the procedure anywhere. Is it under a different title? Name? I don't know where to look. Thanks.

• View comment
• Created January 09, 2020 13:54
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Image backup

I think that the program is looking messy internally. It is going to have few points with one of the UF and some points with other UF. However, physically the robot will go tho the "correct" point ...

• View comment
• Created January 07, 2020 10:47
• 0 votes

1. Community
2. Mechanical Design
3. Gear ratio of motor

Hye ishaq As per best of my knowledge "253.004" should be the one. You will be able to control the start and menu=>maintenance and then check ratio of gear instead of checking it in different varia...

• View comment
• Created December 19, 2019 08:52
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. CRM5 Interface of FANUC

I have strong belief that this interface is for the FANUC's I/O link for having an interference to the robot in direct manner to its controller. For it's manual, i will research and hope to send yo...

• View comment
• Created December 16, 2019 07:43
• 0 votes

1. Community
2. Mechanical Design
3. Is there a way for safe output from robot to pLC

Hi both!In my opinion when you are talking ofthe capability of DCS, then you are inquiring position of DCS and its speed check. right? For the purpose of relaying a signal to that of an SPO, you ar...

• View comment
• Created December 13, 2019 11:41
• 0 votes

1. Community
2. Mechanical Design
3. Arcmate FANUC robot 120iB weave

Hi Juan!The weave plate is following frame tool and as long as the torch is at 45 degrees in horizontal to the plate, there is no problem that you may have in right weave of corner. By the way, hav...

• View comment
• Created December 12, 2019 17:26
• 0 votes