Howard Coleman
Posts
-
What is meant by MOTN049 calibrated in FANUCs?
Hi all, I am having my FANUC LR Mate 100i. Basically it is one of the old models of 1998, however it is of first generation. I have mastered it. Recently I have changed its battery set. Now whener ...
-
Answered
Why digital output never gets off?
My question to you is that my FANUC R20001a/165 robot is having some of its digital output always ON no matter what. I am not able to switch it OFF at any case. These digital outputs are on the DEV...
-
External axis support of FANUC
I am working on my 2 robots. Arcmate 125 having RJ2iB controller and 320iW having RJ2 controller. The first FANUC is mounted on an external axis which is allowing it to move among 2 rotatable weldi...
-
Issues with FANUC robot having cognex camera
Hi all, it's me Howard again. I am currently using a FANUC robot having an on-board cognex camera on its gripper for taking products on its pallet. The position of the products can be varied too, t...
-
Answered
Command "Go" in FANUC robotics
Hey folks!I am having a "Go" command and I don't know its purpose. Can anyone of you tell me about its functionality? The snapshot is attached and it is on "Line 71. Thank You all in advance.
-
Connector of FANUC
Hey all!Is anyone having a connector which is going in the operator panel and is considered for safety orange in color usually having jumpers. I need a couple cause someone stole my backpack with m...
-
Robot is loosing memory when it boot it up
I have my FANUC R-30i and it has an issue. The issue is that my robot is loosing it all memory when I boot up and it has no mechanism for retention of what program was running on power cycle. Is th...
-
Answered
FANUC hangs up...
Hi, My R30iA mate for the 100iC is suddenly hanging up while working.....and it is not working properly. None of the key in teach pendant is not working after powering up and the system doesn't com...
-
Answered
What is best way for transferring data from AB PLC to that of FANUC robots?
Hi........i am interested to know about an issue that i am facing about real data transferring from the AB compact Logic PLC to that of FANUC robot for registration of instruction with help of an E...
-
Can anyone give me suggestions regarding TP memory of the FANUC?
Hi all!I am currently working on the FANUC 30iA. The robot is actually out of memory i.e. TP memory. I have been checking that this FANUC robot is already having a 3m SRAM. Therefore, I believe the...