Martin Butler

1. Community
2. Troubleshooting — FANUC
3. Change robot position with same controller

Fred, It should be fine if your robot's version ID is similar. You will get a pulse mismatch, but you can reset it in the motion/calibration menu.  

• View comment
• Edited April 08, 2020 17:09
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. SRVO-051

The offset of the current feedback value is abnormally high. See which axis in your alarm line.You probably gonna have to replace the servo amplifier.

• View comment
• Created March 30, 2020 13:16
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Teach screen freezes

Hi Freeman, I can't really explain why but here some tips that you should use to avoid it. - Connect your USB into the controller port - Use an empty USB - Connect it and make your backup when your...

• View comment
• Created March 30, 2020 13:00
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. My FANUC is freezing up when I make backup

Seen this problem before, I just change for another USB key and it never happen again.

• View comment
• Created December 12, 2019 14:18
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Transfer Files

You can open a backup all of above: https://forum.diy-robotics.com/hc/en-us/community/posts/360055505432-All-of-above-ROBOGUIDE Or you can load a program the same way as a real robot. There is a fo...

• View comment
• Created December 12, 2019 14:14
• 0 votes

1. Community
2. Electrical Design
3. NON SAFETY INPUT

Hi, Are you trying to map a Di to a Do?

• View comment
• Created December 06, 2019 13:30
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Point touchup

That is because you don't have the same tool frame selected.

• View comment
• Created December 05, 2019 14:00
• 0 votes