Edwin Sherman

1. Community
2. Troubleshooting — FANUC
3. Profinet vs Profibus

Hello ,  - Profinet and Profibus are different communication method. They uses different type of port. Profibus uses 9 Pin connection , while Profinet uses RJ45 cable.  - Profibus has a switch pass...

• View comment
• Created March 16, 2020 13:45
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Roboguide crashes with multiple cell window

I understood. I had faced the similar issue. It is due to the PORT Number. Check the port number of another roboguide trying to open. Check any other software/system running on the same port , Dis...

• View comment
• Created March 10, 2020 15:07
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Roboguide crashes with multiple cell window

Are you trying to open the second roboguide software ?  Just like there is one already opened cell and then on roboguide icon at taskbar , Right click it and opening the another ? 

• View comment
• Created March 10, 2020 15:03
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Spot Weld Count Monitor

May i know which controller do you use ?

• View comment
• Created March 09, 2020 11:54
• 0 votes