Szilagyi Arnold
Comments
-
Finally I found what I missed. I've been talking to somebody today and he gave the idea that maybe it is not voltage driven, that's why I can't measure the voltage. These outputs are current drive...
-
sure
-
How can I do that? The PCB is inside a closed box. A picture from the front you can see in the earlier post while it is powered.
-
-
The main problem is that I don't have 24 v for the outputs on the CRM10 connector on the main board
-
Unfortunately the cabinet doesn't have a ID table (it is painted). I attach some pictures about the cabinet and Version. If don't get out the signal it means that I have problem on my main board? O...
-
Problem solved. One of the connectors was not set correctly. Thanks for the support. I learn a lot from very post.
-
I'm sorry, but I'm newbie in Fanuc systems and I am on my own. This robot is the first Fanuc system in my factory. Where is the lockout switch? For measuring the power in the amplifier, do I need ...
-
gosh. I just realized that the alarm messages were missing from my original post
-
OK, I don't find the drawing for servo amplifiers, where should I check the L1 L2 L3 power. I only find drawing for a newer (modular) amplifier in the documentations. What is this type of amplifi...