Hello guys, I am getting an error on start up of my FANUC robot in the stand alone mode for testing.
The errors are as follows.
INTP-207 (FLT_RSET,1) Group I/O port access and
INTP-206 (CK_LAY,!) Digital port access
The robot is being used in cell and stand alone testing is being performed. Help is needed.
Thank You all
Didn't find what you were looking for?
New post
Dear Laurance,
I have a suspect that you are still having the I/O mapping in old formats. You should go to the configuration page for the DI/DO and the GI/GO and set all of the rack, slot, and start to 0 and reboot.
Your problem will be resolved for sure. goodluck
Dear Frankie,
I implemented your suggestion but problem is persisting.
I think removing the profibus card started this whole problem. I should do the reverse to make it right.
Please sign in to leave a comment.
Comments
2 comments