Laurence Price

Total activity 121
Last activity February 07, 2020 09:26
Member since December 06, 2019 04:43

Following 0 users
Followed by 0 users
Votes 3
Subscriptions 51

Laurence Price commented, February 07, 2020 09:26
Hey Ching, Please check the TP Cable, as it might be causing this trouble. If you are having another robot then swap with it. Good luck
- View comment
- 0 votes
Laurence Price commented, February 06, 2020 12:09
Hi, I think that if you are utilizing it for training purposes such as school, college, or university level use, then you can get its free license. However, I am not sure about it.
- View comment
- 0 votes
Laurence Price commented, February 05, 2020 07:52
Hey Isa, Is there any chance that you might be able to hook-up on the aux axis and tie it up out of the way just for clearing the alarm? After that you may be able to move your robot. I am having t...
- View comment
- 0 votes
Laurence Price created a post, February 04, 2020 05:22
Teh IRVISION for Welding
1. Community
2. Electrical Design
Hello, Does any of you ever succeeded in use of IRVISION for welding purpose of steel like CONEX boxes or beams used for structures or any other sort of sensor technology? I am using my robot M710/...
- 4 followers
- 3 comments
- 0 votes
Laurence Price commented, February 03, 2020 09:36
Hey Juan, The problem has been resolved. I have reinstalled the robot's backup from my system and it is working fine now. Thank You again
- View comment
- 0 votes
Laurence Price commented, February 03, 2020 06:44
Dear Juan, Basically, zeroing is performed after repairing the board. The robot is now able to move in the joint and Cartesian as well but it is hanging while selecting the program to be moved in a...
- View comment
- 0 votes
Laurence Price created a post, February 03, 2020 04:36
Answered

Hanging S420
1. Community
2. Troubleshooting — FANUC
Dear all, I am working on an old version of FANUC robot S420 having an RJ Controller which can move in the mode of manual joint but the problem is that it is hanging when any program is selected an...
- 2 followers
- 3 comments
- 0 votes
Laurence Price commented, January 31, 2020 16:06
Hi Losev, When you are having infor of the "Control Everything" boards, then you may opt for either "Higher Power Relay Board" or "Lower Power Relay Board" or "SSR7 Board" for the control of a powe...
- View comment
- 0 votes
Laurence Price commented, January 31, 2020 15:49
Dear Chang Thriving, I have explored this before, however i discovered that the nature of the 6th axis of the robot is not going to give the accuracy level that is needed. It is depending on the na...
- View comment
- 0 votes
Laurence Price commented, January 31, 2020 15:33
Dear Juan, The ratios of gear for each and every axis is stored in the system parameter "$PARAM_GROUP[1].$GEAR_RATIO". Thank You
- View comment
- 0 votes