1. DIY-Robotics (Help Center)
  2. Community
  3. Troubleshooting — FANUC

Answered Device Net errors

Avatar
Ernesto Perito

Hello everyone,

I Need a little help, on my Fanuc S-430i RJ3 Robot. I am connecting  24 VDC to the card for power the devicenet I am having these Device net error DNET-119 Dup. Mac Ack Fault. And if I do not connect 24 VDC then its DNET-114 Error with DNET-084 Board reset failed error. 

Anyone can help me with these? Its Urgent

Didn't find what you were looking for?

New post

Comments

3 comments

Sort by Date Votes
  • Avatar
    Losev Radinovich
    Comment actions Permalink

    DNET - 119 is because of baud rate difference. Try setting the baud rate below 500ms on both devices. 

    1
  • Avatar
    Sarwat Anjum
    Comment actions Permalink

     
     
    DNET – 084 STOP Board Reset Failed: Bd %d
    Cause: The command to reset the specified board has failed.
    Remedy: Refer to the next D-NET alarm posted in the alarm log for specific alarm recovery information. Go to your I/O and check the details and see if you have more than one card on the same address.
     
    1
  • Avatar
    Ernesto Perito
    Comment actions Permalink

    It has resolved the issue ✌

    Thanks!

    0

Please sign in to leave a comment.