Mathieu Berube

1. Community
2. Troubleshooting — FANUC
3. Program autopause

Hi Sebastien, 1. What is the method of calling programs in auto with your robot (PNS, OTHER, etc) 2. In MENU--SYSTEM--CONFIG, do you start it by Local or remote     DIY-Robotics productshttps://di...

• View comment
• Created March 02, 2021 12:41
• 0 votes

1. Community
2. Electrical Design
3. Fan Not Working

Hi, What is the exact alarm in the controller

• View comment
• Created January 29, 2021 16:31
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Robot Wall mount

Hi, Did you try to enter it in the controller maintenance data:       DIY-Robotics productshttps://diy-robotics.com/products/

• View comment
• Created January 04, 2021 19:05
• 0 votes

1. Community
2. Electrical Design
3. Fanuc S420 RO connection

OK. On the drive there 3 red LED for the alarm. Do you have one LED on?     DIY-Robotics productshttps://diy-robotics.com/products/

• View comment
• Created May 27, 2020 13:39
• 0 votes

1. Community
2. Electrical Design
3. Fanuc S420 RO connection

Can you take a close picture of this one:       DIY-Robotics productshttps://diy-robotics.com/products/

• View comment
• Created May 26, 2020 13:54
• 0 votes

1. Community
2. Electrical Design
3. Fanuc S420 RO connection

Ok but if you want to see if everything is ok you need to plug it to see if there is some led ON near the fuses.  

• View comment
• Created May 26, 2020 13:33
• 0 votes

1. Community
2. Electrical Design
3. Fanuc S420 RO connection

Can you take a picture of the main board to see if there is some fuse broken?     DIY-Robotics productshttps://diy-robotics.com/products/

• View comment
• Created May 26, 2020 12:53
• 0 votes

1. Community
2. Electrical Design
3. Fanuc S420 RO connection

Hi, Can you probe the 24VDC between the pin 17-18-19-20 and the pin 8. Put the COM pin of your multimeter on pin 8 and you are supposed to get 24VDC on 17-18-19 and 20     DIY-Robotics productshttp...

• View comment
• Created May 26, 2020 12:06
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. SRV-044 error

Hi,  This is the lockout switch that you can put a lock on To mesure the power on the amplifier, you need to check the power on thos wire. Be careful because there will be 240VAC on this connecto...

• View comment
• Created May 25, 2020 18:59
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. SRV-044 error

Check the power on the amplifier this will prevent you from checking it on the multi tap transformer because this is a high power source and it can be very dangerous. Check with your maintenance te...

• View comment
• Edited May 25, 2020 18:23
• 0 votes