Mathieu Brodeur
Comments
-
First, check the status.In: Menu /Control Pnael / Safety Controller / Synchronization If Status is red, you will need to Synchronize the robot. Make sure you are logged in as Safety user. Jog the ...
-
Also, note that there is an error in the BOM for R1, R2, R3 resistor value.The adequate resistor is 270ohm, but the BOM links to a 270 k ohm resistor. I suggest the following component:Digi-Key Par...
-
Hi Phil !The way the PC software and Arduino codes are built, it is not possible to upload a robot program on the arduino.The PC software reads the robot program and sends the motors positions via ...
-
Hi Raj,Your post is in the Educative Cell topic of the forum.Which is related to a DIY Educative project (not related to FANUC).Is it intentional ?If you want to connect a OMRON PLC to your DIY Edu...
-
Hi,MOTN-074 (G:1) Message: Error in speed (G:%d^2) Cause: Speed is not within 0 to $speedlim Remedy: Set speed within 0 to $speedlimWhen executing the "Measure Camera's Position" ...
-
Hi,You need to contact FANUC and purchase the PAC (Product Authorization Code) for this option.
-
Hi !Can you jog the robot in manual mode (joint)?Can you check the status of the SafeMove system ? You might need to re-synch your robot.
-
Most suppliers are backorder for those batteries right now... Here's what I found:General Electric FANUC A98L-0031-0011 replacement battery (batteryguy.com)https://batteryguy.com/general+electric+f...
-
Hi Paul, First of all, I can garantee that the provided PC software works on my end.However, it is obvious that many people have problems with it, so it needs to be improved. Keep in mind that this...
-
Hi,You can disable the contact stop from a Digital output (DO[x]).First, set unassigned DO to NSI. In this example, DO[70] = NSI[1]. NSI is RACK 36, SLOT 0 You might have to reboot the robot for th...