Toby cooke

1. Community
2. Electrical Design
3. 12V out From EE connector

R2000ib with r30iB controller 

• View comment
• Created February 01, 2020 17:54
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. SRVO-171

Masako Cynesige  Yeah , We have changed the grease . It was all dark in color since then alarm is not showing up. Thanks 

• View comment
• Created February 01, 2020 17:52
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. SRVO-171

Thanks for the answer. We had a lot of work pressure.We have skipped maintenance since last two times. Can it be the issue ?

• View comment
• Created January 31, 2020 13:57
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Moving the variable of UL layer in to the register

Juan Turner Use following integer  to define.     Then Use CALL GETULXY(1, ‘NUM_LAYERS’, 0, 1, ‘…’, 0, 199)   

• View comment
• Edited January 30, 2020 13:58
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. New program not running

Ernesto Perito   Take all of above back up and open it in roboguide software. See if the file is changed or not. If not changed , Change the file and save it and restore the back up. It will sort o...

• View comment
• Edited January 28, 2020 04:18
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Fanuc robot 120i mate

iqra arshad In your program , Can you confirm the pulse duration welding time. I suppose you need to make adjustment over there.  Thanks 

• View comment
• Created January 25, 2020 19:51
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. SRVO-348

Thank you . Problem was related to E-stop Unit

• View comment
• Created January 25, 2020 19:16
• 0 votes

1. Community
2. Electrical Design
3. Festo Modbus and FANUC Robot's TCP/IP

Muhammad Ishaq As there is not specific error you have mentioned. You need to reconfigure the Master and Slave step by step.  Refer this documentation for Step By Step information on setup.  https:...

• View comment
• Created January 24, 2020 13:54
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Spot welding Pressure adjustment problem

Ernesto Perito   Perform Purge testing as mentioned here. You may have leakage issue.    https://forum.diy-robotics.com/hc/en-us/community/posts/360056343192-Purge-System-Testing- 

• View comment
• Created January 24, 2020 13:49
• 0 votes

1. Community
2. Mechanical Design
3. EWM Welder enabled FANUC connection

Laurence Price Take a look at the connection manual. Make sure you follow the same. If you find any query you can always contact for support.  Here is the configuration link https://www.ewm-group.c...

• View comment
• Created January 24, 2020 13:47
• 0 votes