Chang Thriving

1. Community
2. Troubleshooting — FANUC
3. Connecting R30iA with RS-232

Hey Howard, How are you? Can you please tell me which or what sort of sensor are you intended to use? Waiting to hear from you

• View comment
• Created January 30, 2020 09:37
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Invalid indexing of values for R1=PR1,2

Hi, What is the value of Y in the PR you are trying to write to the register. What is the Representation of the PR Cartesian or Joint?

• View comment
• Created January 14, 2020 08:09
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. INTP205 error

Dear Ishaq, are you getting any other alarms as well? check history? moreover if you are not using the analog I/O then disable it from menu.

• View comment
• Created January 09, 2020 17:59
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. The use of Pallet Tool

Isa, for it is going to be dependent on the software version that you would use.

• View comment
• Created February 07, 2020 17:44
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. The use of Pallet Tool

Actually the unit load is exactly same among both units.  Therefore, is it pallet station or what? You are having the PLC updating the pallet information after each drop and then controlling which ...

• View comment
• Created February 07, 2020 16:47
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. The use of Pallet Tool

Well dear Isa, Yes, this is possible. Please tell me what do you want to know? Thank you

• View comment
• Created February 07, 2020 13:33
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Couple of Questions related to Payload

Hi Howard, Can you please break down your answer to a further easy level? Actually i am not able to get it yet and I am figuring out how it would work. Therefore, I am requesting you to please spec...

• View comment
• Created February 05, 2020 09:03
• 0 votes

1. Community
2. Electrical Design
3. Setup for SMTP

Hi Jordi, Welcome. What is suggestion of FANUC on this? If I were in your place, I would have asked them. Thank You

• View comment
• Created February 04, 2020 07:24
• 0 votes

1. Community
2. Mechanical Design
3. 7th Axis Rail Mastering

Hi Dimitry, The 7th axis of the robot is considered for the motion model which is influencing the direction and speed of the TCP motion. This is requiring certain Kinematics based relationship amon...

• View comment
• Created February 03, 2020 11:30
• 0 votes

1. Community
2. Mechanical Design
3. Tool offset with iRVision

Hi Bailey, It is storing a vision offset in to a VR in vision register. After that you can apply VOffset to the point you have liked but usually it is of destination point. Best of Luck

• View comment
• Created January 31, 2020 16:36
• 0 votes