Laurence Price
Comments
-
Frankie, the answer is very simple and straight forward. Yes you can manage the offset. However you have to be sure whether you want it to move to about 10mm but not 10.2 and 0.3 on either directio...
-
Hello Howard!I have a unique and weird idea for you to resolve your problem and that is whether or not you tried removing teach pendant? Before, I was having few issues similar to what you are faci...
-
Hey Frankie Please try this code. $SCR_GRP[1].$BRK_NUMBER[4] = 0$SCR_GRP[1].$BRK_NUMBER[5] = 0$SCR_GRP[1].$BRK_NUMBER[6] = 0 However, bear it in mind that you must be running the code at start of c...
-
Hey Ching, Please check the TP Cable, as it might be causing this trouble. If you are having another robot then swap with it. Good luck
-
Hi, I think that if you are utilizing it for training purposes such as school, college, or university level use, then you can get its free license. However, I am not sure about it.
-
Hey Isa, Is there any chance that you might be able to hook-up on the aux axis and tie it up out of the way just for clearing the alarm? After that you may be able to move your robot. I am having t...
-
Hey Juan, The problem has been resolved. I have reinstalled the robot's backup from my system and it is working fine now. Thank You again
-
Dear Juan, Basically, zeroing is performed after repairing the board. The robot is now able to move in the joint and Cartesian as well but it is hanging while selecting the program to be moved in a...
-
Hi Losev, When you are having infor of the "Control Everything" boards, then you may opt for either "Higher Power Relay Board" or "Lower Power Relay Board" or "SSR7 Board" for the control of a powe...
-
Dear Chang Thriving, I have explored this before, however i discovered that the nature of the 6th axis of the robot is not going to give the accuracy level that is needed. It is depending on the na...