Masako Cynesige
Comments
-
Dear Fredric, Inertia can be calculated by hand here I am also attaching a link for inertia calculator: https://skyciv.com/free-moment-of-inertia-calculator/ Solidworks can also be used for the ca...
-
Dear Fredric, OS-144 is an operating system error. The only method of troubleshooting is that you should Send MD backup to Fanuc. I have encountered this error and they solved it. So Take a complet...
-
Dear Cherly, Here's what the manual says: ARC-022 Weld AO scaling limit used Cause: The programmed analog output is beyond the equipment limits. Remedy: Check if weld controller is functioning cor...
-
Dear Losev, The fan related alarms are mentioned below: SRVO-049 SERVO OHAL1 alarm (Grp:%d Ax:%d) SRVO-133 SERVO FSAL (PSM) alarm (G:%d A:%d) SRVO-135 SERVO FSAL alarm (G:%d A:%d) SRVO-200 WARN C...
-
Dear Losev, If there's no information available in manuals . You would have to contact FANUC Robotics on this one. Basically it is an internal error you do not see normally. It indicates that contr...
-
Dear Losev, Yes, If your is fine you can replace the encoder only.
-
Hi Toby, You check check the timers to find out the running hours of the robot: GO TO -> Menu -> Next-> Status-> Type-> System Timers. About the second part of your question i'm not sure about res...
-
There! you are getting this all because of delayed maintenance and you should take care of the maintenance. It could possibly cause any other alarms in the near future
-
Hi Toby cooke It is merely a warning you should ignore it. And if you have found it harmful you should increase its severity so that it stops your robot. SRVO-171 WARN MotorSpd lim/DVC(G:%d A:%d) ...
-
Dear iqra, I can guide for few things. You should check the software if it is loaded properly. Also you should press F1 and F5 while starting to start in boot monitor then select INIT Start to veri...