Masako Cynesige

1. Community
2. Troubleshooting — FANUC
3. ISDT-007(G:0, A:1)

Thanks sarwat. 👍

• View comment
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Weld enable mismatch

Thanks sarwat and dimitry for this help 🤗

• View comment
• 0 votes

1. Community
2. Mechanical Design
3. Gear ratios info

Thanks Dimitry, I appreciate the information you provided. ✌

• View comment
• 0 votes

1. Community
2. Electrical Design
3. FANUC HMI R553 option

Oh Thanks for letting me know though. ✌ 

• View comment
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Fanuc Arcmate 120 iC burns tip of the weld

Issue was resolved. it was too many volts for the amount of wire I were using. Thanks

• View comment
• 0 votes

1. Community
2. Mechanical Design
3. Fanuc 2000ic 210f Fence height

It was really helping Sarwat. Thanks! 🤗

• View comment
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. JOG-013

Dear Fredric Demps Please find below explanation of JOG-013 WARN Stroke limit (G:%d A:%x Hex) Cause: Robot axis reaches its specified stroke limit. Remedy: The robot already reach the stroke limit...

• View comment
• 0 votes

1. Community
2. Mechanical Design
3. PAYLOAD CALCULATION

Dear Fredric, Inertia can be calculated by hand here I am also attaching a link for inertia calculator: https://skyciv.com/free-moment-of-inertia-calculator/  Solidworks can also be used for the ca...

• View comment
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. OS-144 System Error

Dear Fredric, OS-144 is an operating system error. The only method of troubleshooting is that you should Send MD backup to Fanuc. I have encountered this error and they solved it. So Take a complet...

• View comment
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. ARC-022

Dear Cherly, Here's what the manual says: ARC-022 Weld AO scaling limit used  Cause: The programmed analog output is beyond the equipment limits. Remedy: Check if weld controller is functioning cor...

• View comment
• Edited February 05, 2020 05:14
• 0 votes