Juan Turner
Posts
-
Answered
The problem of auto run cycle
Hey everyone, I am trying to run my FANUC without requirement of holding the teach pendant's DEADMAN SWITCH and its SHIFT button. Whenever, I am putting the key in controller, it is changing its au...
-
Relationship among Angle of joint and Angular Momentum
Hello all, I am going to ask a simple and straightforward question. Can anyone of you tell me that what is basic relationship among joint angle and motor revolutions? For instance, if one of the j...
-
Answered
Moving the variable of UL layer in to the register
Hello experts, I am in great trouble. I wan to ask about a way for pulling the total number of layers from current running unit loads and sending the information the external PLC. I am aware of eac...
-
4th axis of my robot is not returning to its joint
Hello experts, I am having FANUC M710iC/50 robot having R30B controller. It happens that when I teach the joint a position through another robot, then robot is moving to all of its 6 axis from the ...
-
Disabling the Simulations function of I/O
Hi everyone! I wonder to ask whether is it possible to disable the simulation function of the I/O? I am working on the FANUC having RJ3iB controller.
-
Answered
Issue related to Tandem Welding
Hi all, I often keep on posting the problems that I face. I am having a trouble here again. If I am wishing to feed a wire of welder no 1 to that of welder no 2 then will I be able to switch the we...
-
Answered
Simplifications needed!!
Hello all, I am having M-16iB controller. Assistance is needed as I am having about 20 routines/parts of FANUC which are needed to be run but I am not in mood to give the console to the operator. ...
-
Answered
R30iA controller Torch-mate problem
Hello all, Anyone of you has an idea about torch-mate having DCS on the R30iA controller. Actually I am having an arc-mate 100iC6L and each time when I run torch-mate and then TCP is auto adjusted...
-
Answered
Non-linear issue
Dear all, I am not new to the FANUC robotics but i am having some troubles. I am having my M710iC robot which is a new model and i am having a Research and Development project to look after, theref...
-
Calibration issues with FANUC Tool Center point
Hello, I am working on a project that I am needing to calibrate the TCP for this FANUC robot. Actually, this is an LR Mate 200iC having a controller R30iA and teach pendant. I am having a worksheet...