Juan Turner

Total activity 131
Last activity February 07, 2020 12:30
Member since December 05, 2019 09:34

Following 0 users
Followed by 0 users
Votes 8
Subscriptions 56

Juan Turner commented, February 07, 2020 12:30
Hey Jordi, Are you able to access the variable that you are desiring in the welding register? Here is the way to access. <Data> <Weld Schedule> <Detail> Regards
- View comment
- 0 votes
Juan Turner commented, February 06, 2020 11:43
Dear Vicky, Find attached method. Best of luck
- View comment
- 0 votes
Juan Turner commented, February 06, 2020 10:43
Hi Jordi, The world coordinate system is basically depending on the mastering. By the time you have wall mounted the robot, you are not required to change the mastering, therefore, the world frame...
- View comment
- 0 votes
Juan Turner commented, February 05, 2020 11:10
Hi all, The information of payload is very important for the improvement of movements, basically it is helping in keeping the TCP over a specific programmed path. If the weight of the part is negl...
- View comment
- 0 votes
Juan Turner commented, February 03, 2020 05:50
Dear Laurence, To me it sounds like your robot is most probably not calibrated and is not moving in world. Can you please tell me whether any error is associated to in auto or not?
- View comment
- 0 votes
Juan Turner created a post, February 03, 2020 05:09
Answered

The problem of auto run cycle
1. Community
2. Troubleshooting — FANUC
Hey everyone, I am trying to run my FANUC without requirement of holding the teach pendant's DEADMAN SWITCH and its SHIFT button. Whenever, I am putting the key in controller, it is changing its au...
- 4 followers
- 3 comments
- 0 votes
Juan Turner commented, January 31, 2020 14:03
Dear Muhammad, All I want to ask is that is there exist any approximate relationship among both factors? The basic reason that I want to know of the relationship is the quick mastering. I am intere...
- View comment
- 0 votes
Juan Turner commented, January 31, 2020 11:52
Hi Chadwick, You may look in to this "Application and Control of Robotic Manipulator through PLC". Here is the description that you may be looking for. Good luck with it.
- View comment
- 0 votes
Juan Turner commented, January 31, 2020 11:35
Hello Howard, I think you are required to map the number of bytes at both ends. I have never used Profinet but think it's similar to EIP. Regards
- View comment
- 0 votes
Juan Turner created a post, January 31, 2020 10:58
Relationship among Angle of joint and Angular Momentum
1. Community
2. Electrical Design
Hello all, I am going to ask a simple and straightforward question. Can anyone of you tell me that what is basic relationship among joint angle and motor revolutions? For instance, if one of the j...
- 4 followers
- 4 comments
- 0 votes