Avatar

Michelle Nelson

  • Total activity 12
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 6
Follow

Activity overview

Latest activity by Michelle Nelson
  • Michelle Nelson commented,
    1. Community
    2. Troubleshooting — FANUC
    3. DCS not Visible

    Go to DCS Settings and then apply Target Model , In DCS Cartesian position check , 1st Target Model is by default Robot and 2nd Target model would be your tool. Select and apply to it  

  • Michelle Nelson created a post,
    Answered

    I/O Simulation

    1. Community
    2. Troubleshooting — FANUC

    I have three robotic cell. Two of them have I/O simulated on. But one of them has not. I have checked as mentioned in this thread . But still no solution. Which other settings i can look for it ?? ...

    • 2 followers
    • 1 comment
    • 0 votes
  • Michelle Nelson created a post,
    Answered

    Profinet vs Profibus

    1. Community
    2. Troubleshooting — FANUC

    What is difference between Profinet and Profibus ? How should one select what will be suitable for their application ?  

    • Edited
    • 2 followers
    • 1 comment
    • 0 votes
  • Michelle Nelson created a post,
    Answered

    SYST-045 TP Enabled in Auto Mode

    1. Community
    2. Troubleshooting — FANUC

    Hello Friends, How can i recover from this error ? Please guide me !!  Thank you 

    • Edited
    • 2 followers
    • 1 comment
    • 0 votes
  • Michelle Nelson commented,
    1. Community
    2. Electrical Design
    3. Proximity Switch Connection

    Dimitry Vasilkov Hello , Here is common diagram for proximity connection.    There will be three wires which are required to connect. One wire will be connected to +24 terminal , Another wire will...

  • Michelle Nelson commented,
    1. Community
    2. Electrical Design
    3. VFD connection with Robot

    Charlotte Perrier Hello ,  In general spindle has four pin connection. Which can be connected to VFD with below connection method and VFD can be connected to power supply.   Now with VFD you can c...