Michelle Nelson

1. Community
2. Troubleshooting — FANUC
3. DCS not Visible

Go to DCS Settings and then apply Target Model , In DCS Cartesian position check , 1st Target Model is by default Robot and 2nd Target model would be your tool. Select and apply to it  

• View comment
• Created March 18, 2020 09:45
• 0 votes

1. Community
2. Electrical Design
3. Proximity Switch Connection

Dimitry Vasilkov Hello , Here is common diagram for proximity connection.    There will be three wires which are required to connect. One wire will be connected to +24 terminal , Another wire will...

• View comment
• Created March 03, 2020 09:43
• 0 votes

1. Community
2. Electrical Design
3. VFD connection with Robot

Charlotte Perrier Hello ,  In general spindle has four pin connection. Which can be connected to VFD with below connection method and VFD can be connected to power supply.   Now with VFD you can c...

• View comment
• Edited March 03, 2020 09:44
• 0 votes