Mathieu Berube

1. Community
2. Troubleshooting — FANUC
3. SRV-044 error

Hi, This alarm is related to the servo amplifier.  1.Check the voltage at the servo amplifier. It's not supposed to be higher than 253VAC. If yes, check the main voltage of the controler just to be...

• View comment
• Edited May 25, 2020 15:56
• 0 votes

1. Community
2. Electrical Design
3. Fanuc S420 RO connection

Hi, Can you tell us the version of the Robot? Is tis an RJ2?     DIY-Robotics productshttps://diy-robotics.com/products/

• View comment
• Created May 25, 2020 13:21
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. SRV-044 error

Hi,   Do you have a Fuse broken on the PCB. Check on the Teach the Alarm log if there is some fuse broken.     Thanks     DIY-Robotics productshttps://diy-robotics.com/products/

• View comment
• Created May 25, 2020 13:20
• 0 votes

1. Community
2. Electrical Design
3. New to rc, need help / recommendations

Hi, At DIY-Robotic we do not recommand to remote controle a riding lawnmower, it can be very dansgerous. This is a industrial Robotic forum.   Thanks     DIY-Robotics productshttps://diy-robotics.c...

• View comment
• Created May 15, 2020 15:21
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Fanuc Teach Pendant Status Led

Hi Madison, Can you give us mor info? Do you got a DIY robotic Cell?

• View comment
• Created November 27, 2019 18:31
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Fanuc M20iA, Fault reset function not working

To do a reset with the UI signals, you need to put Enable UI signals at TRUE in the system config

• View comment
• Created November 27, 2019 18:18
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Teach Pendant screen won't open

Hi Duffman, Maybe just do a quick check on the cable of the robot just to be sure that it's not broken. Try to plug well the connector of the cable of the teach because sometime it get loose.

• View comment
• Created November 27, 2019 18:13
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Fanuc LrMate200iC, MOTN-018 Position not reachable

Hi Madison, The point you are trying to reach is in Linear or Joint move? Also, do you have a singularity avoidance on your robot?

• View comment
• Created November 27, 2019 18:07
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Fanuc M20iA, Fault reset function not working

Hi Rejean, Can you precise what you want? Are you in teach mode or auto mode?

• View comment
• Created November 26, 2019 19:55
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Missing Menu

Hi Fanuc Jedi, It seems that the force has left you! You are in quick menu configuration. Press FNCT and QUICK / FULL MENUS and press ENTER:  

• View comment
• Created November 25, 2019 20:59
• 0 votes