Mathieu Berube

Total activity 243
Last activity March 28, 2025 13:01
Member since November 25, 2019 18:35

Following 0 users
Followed by 1 user
Votes 0
Subscriptions 89

Comments

Recent activity by Mathieu Berube

Hi, Can you post the error code you get please?
- View comment
- Created April 12, 2024 12:42
- 0 votes
Hi, can you also show us the alarm code at the left of this message?
- View comment
- Created April 02, 2024 16:51
- 0 votes
Hi, have you wired the 24V with the EAS1 and the 0V with the EAS2? Thanks,
- View comment
- Created April 02, 2024 11:58
- 0 votes
Hi Lena, What error code do you have?
- View comment
- Edited February 06, 2024 12:40
- 0 votes
Hi Daniel, Are you using the PaletPro Software for your patern?
- View comment
- Created February 06, 2024 12:38
- 0 votes
Hi Daniel, It's because the point you try to reach is very close to the axis 5 limit. Can you go on the point and show us the joint value?
- View comment
- Created February 05, 2024 21:02
- 0 votes
Hi Patu, With this error, it's either the pulse coder or the cable. Since the error happened of the 5th axis and after the 4th, check if there's some visible damage on the exposed cable (you may ha...
- View comment
- Created December 21, 2023 12:40
- 0 votes
Hi, Can you dive us the error code? Does the error still ON when you do a Abort All?
- View comment
- Edited November 06, 2023 13:20
- 0 votes
Hi, Are you using a PalletPro option in the robot?
- View comment
- Created September 25, 2023 16:46
- 0 votes
Hi, You can verify the options installed in the robot by pressing STATUS - F1 (TYPE) - Version ID Then press NEXT and press F3 (ORDER FI) You will then see the option installed on the robot.
- View comment
- Edited September 25, 2023 15:35
- 0 votes