iqra arshad

1. Community
2. Troubleshooting — FANUC
3. 4D view on teach pendant

The “4D Graphics” function is available as an option, with a model of the cell loaded into the robot controller. This model can be displayed by pressing the MENU button and selecting “4D Graphics”:...

• View comment
• Created February 03, 2020 17:18
• 0 votes

1. Community
2. Mechanical Design
3. Over Heating

Hi Ernesto, It could possibly be the harsh environment your robot is operating in or one of the below mentioned causes: Insufficient gear or reducer lubricant, OEM Recommended lubricant/grease not ...

• View comment
• Created January 19, 2020 09:48
• 1 vote

1. Community
2. Mechanical Design
3. Robot's Irregular Vibrations while Jogging

Thanks, good to know you have encountered a similar issue, I think you are right the reducer is gone bad. its been a while that we did its maintenance.

• View comment
• Created January 08, 2020 16:25
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. I/O ROBOT OUT

Hi, Use DMM and Check your cable for a short?

• View comment
• Created December 16, 2019 17:16
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Command "Go" in FANUC robotics

Hi, Go through this tutorial in Knowledge base. https://forum.diy-robotics.com/hc/en-us/articles/360035963532-Sending-numeric-data-with-DO-x-using-GO-x-  https://forum.diy-robotics.com/hc/en-us/art...

• View comment
• Created December 16, 2019 14:26
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Fanuc robot 120i mate

Dear Toby, My Welding Time: 1.5 msec  

• View comment
• Created February 07, 2020 04:31
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Inaccurate path

Dear Chadwick, Please state which Robot, Controller & process you are using, It would be easier to help then. Best!

• View comment
• Created January 21, 2020 13:18
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Roboguide v8.2 Error

Dear Ernesto! You need to have that controller version installed. It is revision specific. I don't remember how far back Roboguide supports controllers but it is a possibility that your controller ...

• View comment
• Created January 16, 2020 13:01
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. SRVO-310

Dear Dimitry, As you said you have encountered the alarm after mastering, most probably its because of the incorrect mastering. SRVO-310 Unexpected Motion(G:%d) Cause: A current robot position that...

• View comment
• Created January 13, 2020 16:40
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. SRVO 156 IPMAL Alarm

Thanks Chadwick, I have resolved the issue it was just the elec. panel cleaning missing ..and i came to know that negligence in maintenance does cause alarms. Thanks anyway :)

• View comment
• Created January 12, 2020 08:10
• 0 votes