Sarwat Anjum

1. Community
2. Mechanical Design
3. Soft Float

Dear Toby, I can give you an idea about softfloat option. SOFT FLOAT is used in processes to compensate for unexpected variances. Due to occurrences of these variances, Softfloat allows the robot p...

• View comment
• Created January 28, 2020 17:05
• -1 votes

1. Community
2. Troubleshooting — FANUC
3. SRVO-062

Dear toby, I Found this in the knowledge base link also attached:  SRVO-062 BZAL alarm (G :x A :x) or SRVO-084 BZAL alarm Encoder batteries have low voltage or the encoder cable is disconnected. ht...

• View comment
• Created January 12, 2020 12:07
• -1 votes

1. Community
2. Electrical Design
3. way to run robot without teach pendant

Hi laurence, Yes you can! Fanuc sells a plug that you can apply inside of the controller to jumper out the pendant. This allows the Estop circuit to remain ok. and you can use robot without Teach p...

• View comment
• Edited January 09, 2020 13:52
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. INTP205 error

Hi Muhammad, INTP-205 is an analog port access error. If you are not using anolog I/O then simply GO TO MENU, I/O and disable the analog I/O.  

• View comment
• Created January 09, 2020 13:37
• -1 votes

1. Community
2. Troubleshooting — FANUC
3. How to send data from PLC to Robot

Hi Laurence! You can use FL-NET OPCN-2 (the generic term for a network featuring FA link protocol) interface module. The FA link protocol is intended for the FL-net to be used for data exchange bet...

• View comment
• Created December 19, 2019 09:33
• -1 votes

1. Community
2. Troubleshooting — FANUC
3. Brakes of my FANUC are abnormal.

Hi Frankie! As per manual if Servo 0-18 An excessive brake current is detected. The seven-segment LED on the servo amplifier indicates 1. (Action 1) Check the robot connection cable (RM1) and cable...

• View comment
• Created December 11, 2019 06:30
• -1 votes

1. Community
2. Troubleshooting — FANUC
3. GE FANUC 90 30 PLC

Apologies for misunderstanding the Programming Software with troubleshooting software Please find below Programming Software for GE 90-30 PLC Logicmaster 90-30 is a DOS-based program that runs on ...

• View comment
• Created December 07, 2019 18:22
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. SRVO-046

Hi Toby, You are getting this alarm probably because you haven't set your axis limits properly. This is an OVC alarm, you need to check your axis limit/Set axis limits.

• View comment
• Created January 12, 2020 11:26
• -2 votes

1. Community
2. Troubleshooting — FANUC
3. Brakes of my FANUC are abnormal.

Source : FANUC ROBOTICS SYSTEM R-J3 TROUBLESHOOTING AND MAINTENANCE MANUAL

• View comment
• Created December 11, 2019 06:32
• -2 votes