Sarwat Anjum

1. Community
2. Troubleshooting — FANUC
3. GE FANUC 90 30 PLC

Hi There! You have the choice of three different software packages for troubleshooting your GE 90-30. They are: Logicmaster 90-30. As the original software for the Series 90-30 PLC, it’s DOS-base...

• View comment
• Created December 07, 2019 18:12
• 1 vote

1. Community
2. Mechanical Design
3. Which variables to change for ceiling mounted Fanuc Robot

Hi there! Nice to answer your question here. It is confirmed that the orientation of world frame remains the same, it is not affected by the robot mounting. for example a Robot mounted upside down ...

• View comment
• Created December 05, 2019 18:05
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. RS232 PORT Error

Hi there! RS232 PORT is very susceptible to electrical surges, you would be getting alarm 86 on your screen. This alarm indicates the RS232 Port error.Troubleshoot the problem step by step. Set you...

• View comment
• Created December 03, 2019 17:06
• 1 vote

1. Community
2. Troubleshooting — FANUC
3. Fix Alarms

Dear Iqra, Your Fanuc robot likely has the incorrect time set in the pendant If you are seeing alarms that occurred in the future (ie. 'one hour from now'), this usually indicates the time settings...

• View comment
• Created February 06, 2020 15:43
• 0 votes

1. Community
2. Electrical Design
3. Roboguide to Plc

Hi Yes, there is a possibility to connect roboguide to PLC. I have tried connecting roboguide with PLC, on the same laptop, and also on different laptops(one with roboguide, one wuth simulator plc)...

• View comment
• Created February 06, 2020 06:43
• 0 votes

1. Community
2. Mechanical Design
3. Paint Code

Hi Vicky, You can go for Yellow RAL 1021.  I have tried this one, it Looks Great!

• View comment
• Created February 05, 2020 12:00
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Alarm SRVO-105

Hi,  Here what manual says about SRVO-105 SERVO Door open or E.Stop Cause: Controller door is opened or E.Stop signals are detected for a quite short time or mis-wiring of hardware connection. Re...

• View comment
• Created February 03, 2020 13:22
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. SRVO-005

Dear Chadwick, SRVO-005 SERVO Robot overtravel alarm is explained in detail below: Cause: A Robot overtravel limit switch, is pressed. Remedy: To determine which axis is overtraveled: 1. Press MEN...

• View comment
• Created February 02, 2020 10:51
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. PCMCIA SLOT

Hi, it's possible that one or more of the internal pins are bent. 

• View comment
• Created February 02, 2020 07:36
• 0 votes

1. Community
2. Troubleshooting — FANUC
3. Robot not powering up

Dear Braylen, You should check all the fuses. May be its a blown fuse.

• View comment
• Created February 01, 2020 13:50
• 0 votes